About This Item

Share This Item

The AAPG/Datapages Combined Publications Database

GCAGS Transactions

Abstract


Gulf Coast Association of Geological Societies Transactions
Vol. 27 (1977), Pages 41-43

Previous HitCriticalNext Hit Water Estimates for Gulf Coast Sands

Raymond J. Granberry (1), Dare K. Keelan (2)

ABSTRACT

Hydrocarbon productive sands in the Gulf Coast area exhibit wide variances in formation water saturation (Sw). Values ranging from 10 to 70 percent pore space are common. These variances are related to the capillary properties of the sand, height above the water level, fluid interfacial tensions, and density difference of the entrained fluids. This formation water may, or may not flow in appreciable quantities, depending on the water retentive characteristics of the rock, the formation relative permeability and fluid viscosities. The combined influence of these variables results in a Previous HitcriticalNext Hit upper limit for formation water saturation, above which a significant percentage of water will be produced. This limiting water saturation exceeds the irreducible saturation value and has been called the Previous HitcriticalNext Hit interstitial water (Sciw). It can be correlated with the basic rock properties of permeability and porosity.

Presented herein is a generalized correlation of Previous HitcriticalNext Hit interstitial water saturations for Gulf Coast sands. This correlation allows a Previous HitcriticalNext Hit saturation to be estimated from permeability and porosity data given in a routine core analysis report. Higher Previous HitcriticalNext Hit water saturations are found as porosity increases in samples of constant permeability. Higher values are also noted as permeability decreases in samples of constant porosity. The Previous HitcriticalNext Hit interstitial water saturation also influences the interpretation of the quick-look computer calculated apparent water resistivity (Rwa) curve used to predict hydrocarbon productive zones. The Rwa/Rw multiple of three which is commonly used to indicate hydrocarbon production corresponds to a water saturation of 58 percent of pore space. Low permeability zones may yield hydrocarbons with a Rwa multiple of two, which corresponds to a water saturation of 70 percent. High permeability sands may require multiples of six or more to be hydrocarbon productive. The required multiple for a sample of any given permeability and porosity can be estimated from the generalized correlation of Previous HitcriticalTop water values presented.


Pay-Per-View Purchase Options

The article is available through a document delivery service. Explain these Purchase Options.

Watermarked PDF Document: $14
Open PDF Document: $24