About This Item
- Full text of this item is not available.
- Abstract PDFAbstract PDF(no subscription required)
Share This Item
The AAPG/Datapages Combined Publications Database
Houston Geological Society Bulletin
Abstract
Abstract:
Thermal
Modeling - Oil or Gas?
Examples from the Faroes-Shetland (NW Europe) and
Casamance (NW Africa) Basins
Thermal
Modeling - Oil or Gas?
Examples from the Faroes-Shetland (NW Europe) and
Casamance (NW Africa) BasinsBy
Global Exploration Services Ltd.
West Sussex, UK
From the South China Sea to the deepwater of West Africa,
basin modelers frequently predict gas, yet oil is found. This
presentation reviews where the modeling was in error and how
the science can be put right.
Examples will be shown of how
the oil window may be deeper than
traditionally modeled in some
basins (e.g., Faroes-Shetland
Basin), and how it can be shallower
in other basins (e.g., Casamance
Basin). In the latter case, the origin
of the 2BBO plus oil charge to the
Dome Flore discovery is now readily
apparent whereas in the past it was
necessary to draw on unproven
source horizons. The message is
that charge risks cannot be properly
assessed, in either frontier basins
or established plays, until the correct
thermal
model is applied.
Probably the most difficult task
facing the basin modeler is the
prediction of an accurate heat flow
history. The most widely used
method for
thermal
history
prediction involves the use of
maturation
parameters, e.g., vitrinite reflectance in a kinetic
model. With time provided by the stratigraphy, the
thermal
history is obtained by comparing the predicted and observed
vitrinite reflectance data and adjusting the
thermal
history so
that the predicted and observed values are the same. This can
rarely be achieved without violating the
thermal
predictions of
the established basin subsidence models (McKenzie, 1978), or
without incorporating anomalies
such as a heat flow pulse
(Jensen and Dore, 1993). In
some cases the basin subsidence
thermal
history models are
ignored and a constant heat
flow is applied. Geologists then
have to devise other features to
account for the hydrocarbon
occurrences; for example,
'holding tank' (Dore ct al.,
1997) or 'whoopee cushion'
models (Iliffe et al., 1999) in the
Faroes-Shetland Basin.
As there is much more mass in the rocks than the vitrinite, the subsidence and exhumation histories of the rocks in a basin must provide the primary source of information from which the heat flow history can be determined. However, the vitrinite reflectance values predicted by heat flow histories obtained from tectonic models are much higher than the observed values. This has led geochemists and basin modelers to question the accuracy of tectonically derived heat flows (Yalcin et al., 1997; Waples, 1998).
Figure 1. Location map.
End_Page 15---------------
As there cannot be two different heat flow histories for any one
point in a basin, discrepancies will occur between the heat flows
obtained by the tectonic and the
maturation
calibration methods,
mainly as a result of a flaw in the kinetic models used for
heat flow modeling. Removing this flaw allows the use of a single
heat flow history to predict both the tectonic development
and the
maturation
and hydrocarbon generation histories.
The kinetic models used for
maturation
assessment assume that
time and temperature control the reactions. However, these
models fail to recognise the importance of pressure in a gas
phase reaction. Vitrinite generates gas during
maturation
and
while an increase in temperature increases the rate at which the
reaction proceeds, increasing pressure reduces the rate at which
the reaction occurs (Carr, 1999). This relationship between the
influences that temperature and pressure have on a chemical
reaction is known as Le Chatelier's principle. As high pressures
retard
maturation
, the incorporation of pressure into a kinetic
model (PresRo®) enables the vitrinite reflectance data to be
modeled in high-pressure areas such as the Faroes-Shetland
Basin. The
thermal
model developed for this basin contains
elevated heat flows during the three periods of Cretaceous
rifting, a further period of heat flow associated with the end of
Paleocene volcanism, and a smaller event associated with the
Oligocene-Miocene compression that exists along much of the
NW European Atlantic margin. The use of the PresRo model
overcomes the problem observed by modelers using a nonpressure
dependent kinetic system, namely, that while their
models indicate the source rocks should have generated significant
quantities of gas, the hydrocarbon discoveries contain very
little gas (GOR ~ 0.1). The PresRo model indicates that the
maturation
and hydrocarbon generation of the source rocks is
being retarded by the high pressures in the basin, and that oil as
opposed to gas, will be the main product generated.
In the case of shelf margin basins in northwest Africa, e.g., the
Casamance Basin of southern Senegal and northern Guinea-
Bissau (Figure I), the sedimentary succession is rarely
overpressured although, as in overpressured basins, the vitrinite
reflectance values of the main source rock (Cenomanian to
Turonian) are generally low (< 0.6% Ro). The source rock therefore,
appears to be relatively immature in the region of the Dome Flore oil discoveries, which contain approximately
1x109 BBLS of
12- 13° API (biodegraded) oil. It is also impossible to model the
maturation
of the wells in this area with a heat flow history
based on the tectonic development of the basin. However, the
reflectance values obtained from these organically rich (Type II
kerogens) source rocks are suppressed and removing the effects
of this suppression enables a heat flow history based on the
McKenzie (1978) rift model to be used. The Cenomanian-
Turonian source rocks are actually mature for oil generation over a significant
proportion of the shelf. Given the quality and extent of these mature source
rocks and the emplacement of at least 2x109 BBLS of 35° API oil prior to biodegradation, there is
no need to invoke the presence of an alternative source rock.
Figure 2 illustrates, for the Dome Flore region, the previously
applied top peak oil window and the shallower corrected oil
window. The difference is 900 meters.
In the Faroes-Shetland and Casamance Basins the
maturation
modeling forms part of a single consistent model that accounts
for both tectonic development and hydrocarbon generation.
The ability to model independent parameters, e.g., tectonics and
maturation
within a single heat flow history, is an indication of
the accuracy of the
thermal
model. Finally, the use of an
accurate
thermal
model reduces the risk associated with hydrocarbon
generation and produces an overall improvement in the
understanding of the petroleum systems operating in a basin.
References
Carr, A. D. 1999. A vitrinite reflectance kinetic model incorporating over pressure retardation. Marine and Petroleum Geology, 16, 353-377.
Dore, A. G., E. R Lunden, O. Birkeland, P. E. Ellassen, and L. N. Jensen, 1997. The NE Atlantic Margin: implications of late Mesozoic and Cenozoic events for hydrocarbon prospectivity. Petroleum Geoscience, 3, 117-131.
Iliffe, J. E., A. G. Robertson, G. H. F. Wynn, S. D. M . Pead, and N. Cameron, 1999. The importance of fluid pressures and migrahon to the hydrocarbon prospectivity of the Faeroes-Shetland White Zone. In: A.J. Fleet and Boldy S.A.R. (eds.) Petroleum Geology of Northwest Europe: Proceeding of the 5th Conference. Geological Society, London, 601-611.
Jensen, R. P. and A. G. Dore, 1993. A recent Norwegian Shelf heating event fact or fantasy? In: A. G. Dore et al. (eds.) Basin Modeling: Advances and Applications. NPF Special Publication 3, Elsevier, Amsterdam, 85-106.
McKenzie, D. 1978. Some remarks on the development of sedimentary basins. Earth and Planetary Science Letters, 40.25-32.
Waples, D. W. 1998. Basin modelling: how well have we done? In: Duppenbecker, S. J. and Iliffe, J. E . (eds.) Basin Modelling: Practice and Progress. Geological Society London Special Publication No. 141, 1-14.
Yalcin, M. N., R. Littke, and R. F. Sachsenhofer, 1997.
Thermal
history of
sedimentary basins. In: Welte, D. H., Horsfield, B. and Baker, D. R (eds.)
Petroleum and Basin Evolution, Springer, Berlin, 73-167.
End_Page 16---------------
Figure 2. An illustration showing correct placement for the oil window. when overpressure retardation and vitrinate suppression are accounted for, using the PresRo® program. It is now evident that Dome Flore and Dome Gea were charged from the known source section and there is no longer any need to rely on an unproven Albian source. This display was re-drawn, re-interpreted. and is presented by FIRST EXCHANGE Corp. as exclusive agent for the AGC (the Agency for JointCooperation between Guinea Bissau & Senegal) using materials available to that controlling government agency (AGC) in reports relinquished to the AGC and originally provided by Atlantic Resources. Beicip and Petroconsultants.
End_of_Record - Last_Page 17---------------