About This Item
- Full text of this item is not available.
- Abstract PDFAbstract PDF(no subscription required)
Share This Item
The AAPG/Datapages Combined Publications Database
Houston Geological Society Bulletin
Abstract
Abstract: Developing an Exploration Tool in a Mature Trend:
a 3-D AVO Case Study in South Texas
Edge Petroleum Corporation, Houston, Texas
If at first you don’t succeed, try something unconventional.
Successful exploration for new reservoirs in mature trends
often requires trying techniques unproven in the area. The
mature Oligocene Vicksburg play in south Texas has been heavily
explored since the 1920s (Figure 1) using subsurface geology and
structural
mapping based on conventional seismic data. There is
a scarcity of direct hydrocarbon indicators such as bright spots
that have been key to much of the success in other Tertiary
formations in the region. Our initial exploration campaign with
conventional 3D seismic was disappointing. However, attention
to rock properties coupled with application of a novel processing
technique allowed us to develop a solution to our dilemma.
In the 1990s a large nonexclusive 3-D seismic survey which was acquired in the area led to increased exploratory activity. The prime motive for the 3-D was to image the complex faulting and resulting compartmentalization of the Vicksburg. Given the mature nature of the area, typical exploration targets are moderatepotential fault blocks in productive intervals and higher-potential targets in deeper, untested section.
Edge Petroleum and Carrizo Oil and Gas licensed a 450-mile2
portion of the 3-D survey. Early work led to the identification an
drilling of several Vicksburg structural
traps, resulting in one
commercial gas discovery, one noncommercial discovery, and three
dry holes. Given the moderate potential of the prospects, a 20%
success ratio meant the economics of our exploration program
were marginal. Hence, we were prompted to search for an
exploration tool that would help us to improve our success rate.
Two prospects drilled a few miles apart in our initial exploration campaign targeted Vicksburg sandstones at 5500-7500 ft. Our technical evaluation showed them to have analogous stratigraphy, structure, timing of trap formation, and proximity to source. Neither exhibited anomalous seismic amplitude. Drilling found the predicted reservoir facies in both. However, one was a commercial gas discovery and the other a dry hole (Figure 2). Perplexed and challenged by these results, we selected these two prospects as our laboratory for developing a better risk-assessment technique.
Figure 2. Two geologically similar prospects resulted in a gas discovery
and a dry hole. Structure
maps
and conventional migrated
sections
are
shown.
Seismic models were generated using dipole sonic data gathered in the discovery well. The models suggested that Class 2 AVO anomalies would be associated with Vicksburg gas reservoirs. A pilot reprocessing study demonstrated that known gas reservoirs generate Class 2 AVO anomalies and that seismic incident angles greater than about 26 degrees are required to observe them. It was observed that the application of conventional normal moveout resulted in improper imaging of the far offsets needed to discern the Class 2 anomaly. However, reprocessing the data utilizing nonhyperbolic moveout produced usable data at incident angles of up to 40 degrees, resulting in proper stacking of the needed far offsets (Figure 3).
Resulting angle stacks were visualized on a workstation. Several untested AVO anomalies were identified, including stratigraphic traps.
Wildcat drilling based on this effort resulted in six commercial discoveries and two dry holes, a success rate significantly higher than
was achieved through conventional subsurface geology and structural
mapping in this mature play.
End_of_Record - Last_Page 53---------------