About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Bulletin
Abstract
AAPG Bulletin, V.
1Manuscript received February 13, 1998; revised manuscript received June 28, 1999; final acceptance September 3, 1999.
2Terra Porosa, Independent Consultants, 11839 Cedar Pass Drive, Houston, Texas 77077; e-mail: [email protected]
3Baker Atlas, Geoscience, 10205 Westheimer, Houston, Texas 77042; e-mail: [email protected]
ABSTRACT
regime
during the Eocene-Miocene Alpine compression that caused the
formation of joints and strike-slip faults. Because the matrix porosity in the dolomites
is low (<5%) and poorly connected, joints and faults are essential to connect vugs and
to provide permeability. Field observations of the Sella Group explain why many dolomite
reservoirs and aquifers in strike-slip/compressive tectonic regimes are intensely jointed
when they are mildly deformed. In this type of tectonic
regime
, in fact, pervasive
jointing over a wide area accommodates small strains and is strictly associated with the
formation of strike-slip faults. Our observations allow us to recognize different kinds of
fault
architectures that correspond to different stages of
fault
development. In addition,
theoretical models and microscopic observations were used to estimate the petrophysical
properties of the faulted and jointed dolomite. Small-offset faults (offsets up to 30 mm),
characterized by en echelon arrays of joints and pockets or seams of breccia up to 10 mm
wide, form areas of high permeability (100-3000 md) due to the presence of many joints and
high-porosity breccia. Faults with 1-10 m offsets, characterized by a breccia zone (1-2 m
in width) and associated with high joint density in the wall-rock, contain high-porosity
(10%) breccia and represent areas of preferred fluid flow. Large-offset faults with
offsets more than 10 m contain a wide zone of low-porosity (<1%) breccia and form
potential permeability barriers. The areas adjacent to the intermediate- and large-offset
faults have high permeability (100-3000 md) because of high joint densities. An important
implication of the way faults develop in dolomite is the consistent relationship between
the orientation of joints and faults: the
fault's
strikes differ 15-35° from the strikes
of the pervasive joint systems. Joint density also increases four to five times in the
proximity of the faults. Such relationships can be used to predict the distribution and
orientation of joints and faults in subsurface dolomite reservoirs.
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
Watermarked PDF Document: $14 | |
Open PDF Document: $24 |
AAPG Member?
Please login with your Member username and password.
Members of AAPG receive access to the full AAPG Bulletin Archives as part of their membership. For more information, contact the AAPG Membership Department at [email protected].