The Effect of Ductile-Lithic Sand Grains and Quartz Cement on Porosity and Permeability in Oligocene and Lower Miocene Clastics, South China Sea: Prediction of Reservoir Quality¹

R. H. Worden,² M. Mayall,³ and I. J. Evans⁴

©Copyright 2000. The American Association of Petroleum Geologists. All rights reserved.
¹Manuscript received June 8, 1998; revised manuscript received June 14, 1999; final acceptance September 3, 1999.
²School of Geosciences, The Queen's University Belfast, Belfast BT7 1NN, United Kingdom; e-mail: [email protected]
³BP-Amoco, Sunbury Research and Engineering, Chertsey Road, Sunbury on Thames, Middlesex TW16 7LN, United Kingdom.
⁴BP-Amoco, Sunbury Research and Engineering, Chertsey Road, Sunbury on Thames, Middlesex TW16 7LN, United Kingdom. Present address: BP-Amoco, Sherwood House, Holton Heath Trading Park, Poole, Dorset BH16 6LS, United Kingdom.

ABSTRACT

Ductile, clay-rich sand grains control porosity and permeability in the fluvio-deltaic Oligocene and lower Miocene sandstones of the South China Sea. Ductile grains account for between approximately 5 and 50% of the original sand grain population. There is a pronounced loss of porosity with increasing burial depth in the basin. At depths of less than 3000 m this is due solely to ductile grain compaction where the rate of porosity loss with depth increases with increasing ductile grain content. At depths greater than 3000 m, the steep porosity loss with depth is due to combined ductile grain compaction and quartz cementation. The amount of quartz cement increases with increasing burial depth; however, cleaner sandstones tend to have greater amounts of quartz cement at any given depth below 3000 m. This leads to convergence of porosity evolution for the clean and ductile-rich sandstones below 3000 m. There is a rapid loss of permeability with decreasing porosity because compaction of ductile grains smears them between rigid quartzose grains leading to blocked pore throats. A consequence of this process is that the lowest permeabilities are found in sandstones with the highest ductile grain contents. Quartz cement does not have a clear and discernible control on permeability. The pronounced loss of porosity with increasing depth and permeability with decreasing porosity leads to low permeability at relatively shallow burial depths. Reservoir quality is thus controlled by the nature of the primary sand and depth of burial. The sediment supply system led to systematic changes in ductile grain content across the basin with ductile content increasing into the more distal part of the sediment system. The consequence is that depth of economic basement (in terms of porosity or permeability) can be predicted as a function of ductile grain content and burial depth for prospects across the basin.