About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Bulletin
Abstract
AAPG Bulletin, V.
2003. The American Association of Petroleum Geologists. All rights reserved.
Capillary effects on
fault
-fill sealing
![Previous Hit](/data/images/arrow_left.gif)
![Next Hit](/data/images/arrow_right.gif)
Alton Brown1
11603 Waterview Drive, Richardson, Texas, 75080; email: altonabrownyahoo.com
AUTHORS
Alton Brown worked as a research geologist at ARCO's Plano, Texas, Research Center from 1980 until ARCO's merger with BP. Since then, he has been an independent consultant. His research interests include petroleum migration, carbonate sedimentology and diagenesis, basin analysis, and gas geochemistry.
ACKNOWLEDGMENTS
I thank Russell Davies for constructive comments early in manuscript preparation and for later reviews and suggestions. I also thank AAPG reviewers Quentin Fisher and Jim Handschy for additional comments and suggestions.
ABSTRACT
Capillary-pressure models and concepts were used to evaluate the effects of excess pressure, capillary hysteresis, and relative permeability on fault
-fill sealing. Overpressured
fault
fill (
fault
water pressure higher than reservoir water pressure) always increases the height of the sealed petroleum column. The sealing interface moves into the overpressured
fault
fill where water flows from the
fault
into the reservoir. Underpressured
fault
fill decreases petroleum column height only where cross-
fault
water flow is absent. If water flows across the
fault
, column height is unaffected. Water cannot flow across faults where the reservoir is at irreducible water saturation.
Relative permeability smoothes the transition from membrane sealing to leakage, and thus, hydraulic-resistance sealing is possible after membrane-seal failure. The height of membrane sealing by homogeneous, water-wet fault
fill exceeds the height of hydraulic-resistance sealing at geological leakage rates. Hydraulic-resistance sealing becomes more significant when charge and leakage are both high, when trap life is short, and during production.
Trap leakage rate through a water-wet, fault
-fill pore network cannot exceed trap charge rate during initial trap charging. If charging slows, leakage exceeds charge until a new equilibrium column height develops. If charge stops, the seal continues to leak until the petroleum column height is reduced substantially below its original height. Membrane sealing is reestablished at low capillary pressure. Theoretically, restored seal capacity is close to the original capacity.
Cross-fault
pressure and petroleum column height cannot be converted to seal capacities because charge history and seal type influence sealing. Cross-
fault
pressure data should be analyzed in light of the charge and pressure history so the different controls on
fault
-fill sealing can be assessed.
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
Watermarked PDF Document: $14 | |
Open PDF Document: $24 |
AAPG Member?
Please login with your Member username and password.
Members of AAPG receive access to the full AAPG Bulletin Archives as part of their membership. For more information, contact the AAPG Membership Department at [email protected].