In addition to seismically mapped fault structures, a large number of faults below the limit of seismic resolution contribute to subsurface deformation. However, a correlation between large- and small-scale faults is difficult because of their strong variation in orientation. A workflow to analyze deformation over different scales is described here. Based on the combination of seismic interpretation, coherency analysis, geostatistical analysis, kinematic modeling, and well data analysis, we constrained the density and orientation of subseismic faults and made predictions about reactivation and opening of fractures.

We interpreted faults in seismic and coherency volumes at scales between several kilometers and a few tens of meters. Three-dimensional (3-D) retrodeformation was performed on a detailed interpreted 3-D structural model to simulate strain in the hanging wall at the time of faulting, at a scale below seismic resolution. The modeling results show that (1) considerable strain is observed more than 1 km (0.62 mi) away from the fault trace and (2) deformation around the fault causes strain variations, depending on the fault morphology. This strain variation is responsible for the heterogeneous subseismic fracture distribution observed in wells. We linked the fracture density from the well data with the modeled strain magnitude and used the strain magnitude as a proxy for fracture density. With this method, we can predict the relative density of small-scale fractures in areas without well data. Furthermore, knowing the orientation of the local strain axis, we predict a fault strike and opening or reactivation of fractures during a particular deformation event.