About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Bulletin
Abstract
AAPG Bulletin, V.
2013. The American Association of Petroleum Geologists. All rights reserved.
DOI:10.1306/09071211191
Three-dimensional structure of experimentally produced clay smears: Implications for fault
seal
analysis
![Previous Hit](/data/images/arrow_left.gif)
![Next Hit](/data/images/arrow_right.gif)
N. Bozkurt Ciftci,1 Silvio B. Giger,2 Michael B. Clennell3
1Commonwealth Scientific and Industrial Research Organization, Earth Science and Resource Engineering, P.O. Box 1130, Bentley, Western Australia 6102; [email protected]
2Commonwealth Scientific and Industrial Research Organization, Earth Science and Resource Engineering, P.O. Box 1130, Bentley, Western Australia 6102, Australia; present address: National Cooperative for the Disposal of Radioactive Waste (Nagra), Hardstrasse 73, 5430 Wettingen; [email protected]
3Commonwealth Scientific and Industrial Research Organization, Earth Science and Resource Engineering, P.O. Box 1130, Bentley, Western Australia 6102; [email protected]
ABSTRACT
The geometries of clay smears produced in a series of direct shear experiments on composite blocks containing a clay-rich seal
layer sandwiched between sandstone reservoir layers have been analyzed in detail. The geometries of the evolving shear zones and volume clay distributions are related back to the monitored hydraulic response, the deformation conditions, and the clay content and strength of the
seal
rock. The laboratory experiments were conducted under 4 to 24 MPa (580–3481 psi) fault normal effective stress, equivalent to burial depths spanning from less than approximately 0.8 to 4.2 km (0.5 to 2.6 mi) in a sedimentary basin. The sheared blocks were imaged using medical-type x-ray computed tomography (CT) imaging validated with optical photography of sawn blocks. The interpretation of CT scans was used to construct digital geomodels of clay smears and surrounding volumes from which quantitative information was obtained. The distribution patterns and thickness variations of the clay smears were found to vary considerably according to the level of stress applied during shear and to the brittleness of the
seal
layer. The stiffest
seal
layers with the lowest clay percentage formed the most segmented clay smears. Segmentation does not necessarily indicate that the fault
seal
was breached because wear products may maintain the
seal
between the individual smear segments as they form. In experiments with the
seal
layer formed of softer clays, a more uniform smear thickness is observed, but the average thickness of the clay smear tends to be lower than in stiffer clays. Fault drag and tapering of the
seal
layer are limited to a region close to the fault cutoffs. Therefore, the comparative decrease of sealing potential away from the cutoff zones differs from predictions of clay smear potential type models. Instead of showing a power-law decrease away from the cutoffs toward the midpoint of the shear zone, the clay smear thickness is either uniform, segmented, or undulating, reflecting the accumulated effects of kinematic processes other than drag. Increased normal stress improved fault sealing in the experiments mainly by increasing fault zone thickness, which led to more clay involvement in the fault zone per unit of source layer thickness. The average clay fraction of the fault zone conforms to the prediction of the shale gouge ratio (SGR) model because clay volume is essentially preserved during the deformation process. However, the hydraulic
seal
performance does not correlate to the clay fraction or SGR but does increase as the net clay volume in the fault zone increases. We introduce a scaled form of SGR called SSGR to account for increased clay involvement in the fault zone caused by higher stress and variable obliquity of the
seal
layer to the fault zone. The scaled SGR gives an improved correlation to
seal
performance in our samples compared to the other algorithms.
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
Watermarked PDF Document: $14 | |
Open PDF Document: $24 |
AAPG Member?
Please login with your Member username and password.
Members of AAPG receive access to the full AAPG Bulletin Archives as part of their membership. For more information, contact the AAPG Membership Department at [email protected].