About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Bulletin
Abstract
AAPG Bulletin, V.
2013. The American Association of Petroleum Geologists. All rights reserved.
DOI:10.1306/02261312120
Building a three-dimensional near-surface geologic and petrophysical model based on borehole data: A case study from Chemery, Paris Basin, France
Paola Sala,1 Marcel Frehner,2 Nicola Tisato,3 O. Adrian Pfiffner4
1Institute of Geological Sciences, University of Bern, Bern, Switzerland; [email protected]
2Geological Institute, ETH Zurich, Zurich, Switzerland; [email protected]
3Geological Institute, ETH Zurich, Zurich, Switzerland; [email protected]
4Institute of Geological Sciences, University of Bern, Bern, Switzerland; [email protected]
ABSTRACT
The fact that velocity models based on seismic
reflection surveys commonly do not consider the near-surface geology necessitates filling the gap between the top of a velocity model and the surface of the Earth. In this study, we present a new workflow to build a shallow geologic model based exclusively on borehole data and corroborated by laboratory measurements. The study area is in Chemery (France), located at the southwestern border of the Paris Basin, where a large amount of borehole data is publicly available. The workflow starts with identifying lithologic interfaces in the boreholes and interpolating them between the boreholes. The three-dimensional (3-D) geometry of the lithologies then allows interpretation of the position, orientation, and offset of fault planes. Given the importance of the fault interpretation in the
modeling
process, a combination of different approaches is used to obtain the most reasonable structural framework. After creating a 3-D grid, the resulting 3-D structural model is populated with upscaled velocity logs from the boreholes, yielding the final near-surface P-wave velocity model. To better constrain the velocity model, we conducted laboratory measurements of P- and S-wave velocities in dry and water-saturated conditions on all lithologies in the model. The laboratory data were used to populate the 3-D near-surface model with VP/VS ratio values. The presented workflow accounts for one-dimensional borehole data and is much more iterative and time-consuming than workflows based on two-dimensional
seismic
sections. Nevertheless, the workflow results in a robust 3-D near-surface model allowing for structural interpretations and revealing the 3-D
seismic
velocity field.
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
Watermarked PDF Document: $14 | |
Open PDF Document: $24 |
AAPG Member?
Please login with your Member username and password.
Members of AAPG receive access to the full AAPG Bulletin Archives as part of their membership. For more information, contact the AAPG Membership Department at [email protected].