About This Item

Share This Item

The AAPG/Datapages Combined Publications Database

Journal of Sedimentary Research (SEPM)

Abstract


Journal of Sedimentary Research
Vol. 91 (2021), No. 2. (February), Pages 197-212
DOI: 10.2110/jsr.2020.122

Experimental study of chlorite authigenesis and influence on porosity maintenance in sandstones

Dimitrios Charlaftis, Stuart J. Jones, Katherine J. Dobson, Jonathan Crouch, Sanem Acikalin

Abstract

Chlorite is recognized as a key mineral for preserving reservoir quality in deeply buried sandstones, as chlorite coatings inhibit the nucleation of quartz overgrowths. A limited understanding of the mechanisms and conditions under which these authigenic chlorite coatings form prevents the accurate forward modeling of diagenesis and limits reservoir quality models critical to a wide range of geoscience applications. We present experimental data that show how authigenic chlorite grain coatings preserve porosity in deeply buried sandstone reservoirs, using a series of hydrothermal reactor experiments to simulate quartz cementation and capture the evolving porosity. To simulate reservoir evolution, berthierine-bearing sandstone samples (Lower Jurassic Cook Formation, Oseberg Field, 30/6-17R, Norway) were exposed to a silica-supersaturated Na2CO3 (0.1 M) solution for 72 hours at temperatures of between 100 and 250 °C. Quantification of the temperature-dependent changes in the volume of authigenic chlorite, the thickness and coverage of the clay coatings, and the sample porosity shows increases in chlorite volume (from ∼ 2% to ∼ 14%). This occurs by the transformation, of patchy amorphous berthierine into grain-coating Fe-chlorite cements through a mixture of the solid-state transformation and dissolution–precipitation mechanisms, siderite replacement, and direct precipitation on clay-free surfaces. With increasing temperature, the chlorite coatings increase from ∼ 3.8 μm to ∼ 5.4 μm thick and expand their grain surface coverage from ∼ 28% to ∼ 50%. The face-to-edge and face-to-face foliaceous structure of the clay coatings produced are morphologically similar to those observed in deeply buried sandstones. Only above temperatures of 175 °C is porosity preserved as a consequence of inhibition of quartz overgrowths and the generation of secondary porosity.

Our quantitative approach enhances our knowledge regarding the temperature and mineral precursor influence on chlorite-coating authigenesis and therefore provides key insight for chlorite grain coatings for reservoir potential in sedimentary sequences greater than 2.5 km.


Pay-Per-View Purchase Options

The article is available through a document delivery service. Explain these Purchase Options.

Watermarked PDF Document: $14
Open PDF Document: $24