About This Item
- Full text of this item is not available.
- Abstract PDFAbstract PDF(no subscription required)
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Special Volumes
Abstract
Fault
-Controlled
By
Originally presented at the 1998 Hedberg (AAPG) Research Conference at Galveston, TX
Book/CD-ROM Title:
Edited by
fault
-controlled
hydrocarbon migration at regional to compartmental scales through analysis of geochemical,
geophysical, geological and production data. Specific problems addressed in this study are
how regional patterns of hydrocarbon migration relate to structural development of the
field and the extent to which faults compartmentalize production.
Ship Shoal 274 and adjoining blocks lie in the Louisiana
OCS, Gulf of Mexico; their geology is characterized by Plio-Pleistocene sediments crosscut
by large- and small-displacement faults. Production occurs in both the footwall and the
hanging wall of a large-displacement arcuate fault
(A, see Figure 1) near its junction
with a N-S trending
fault
(B). Small-displacement (50 ft. or less) faults in the footwall
and hanging wall of the A
fault
form two sets, one that parallels the A
fault
and one that
parallels the B
fault
; it is believed that these faults formed concurrently with faults A
and B, respectively. Both A and B faults formed in response to salt movement and are salt
cored at depth. Based on crosscutting relationships and paleontologic data, it appears
that movement occurred first on
fault
A, while
fault
B and associated synthetics and
antithetics were more recently active.
Map patterns of whole-oil chemistry suggest that evolving
routes of hydrocarbon migration tracked structural development of the field (Figure 1).
Oil with a whole-oil chemistry consistent with that of a parent oil, along with associated
gas, is found throughout the field, and in particular, appears to lie along trends bounded
by small-displacement faults of the A family. Fractionated oils and condensates with an
isotopic signature similar to that of the parent oil are found proximal to the B fault
and
along trends bounded by faults of the B family, along with late-stage gas with a distinct
isotopic signature (possibly derived from a separate source). In particular, fractionated
oils, condensates, and late-stage gas are localized along faults antithetic to B. This
pattern of hydrocarbon geochemistry is explained by early migration of oil and gas up the
A
fault
, perhaps during active deformation, followed by late-stage migration of gas up the
B
fault
(and possibly the NW-SE trending section of the A
fault
), resulting in oil
fractionation and remigration along associated small-displacement faults, as shown in
Figure 2.
Hydrocarbon distribution patterns such as gas emplaced
downdip from oil are consistent with this model for reservoir charge. Such patterns must
be maintained by reservoir compartmentalization. For three sands, detailed maps of oil-
and gas-charged compartments bounded by small-displacement faults were made from amplitude
and edge-detection analysis of seismic data. One of these, of the G sand, is shown
schematically in Figure 1. Size of fault
-bound compartments was estimated from the maps,
then compared to drainage areas modeled from production data for wells producing from
these compartments. For thin discontinuous sands, predicted
fault
-bound compartment size
closely matches drainage area. For thicker sands such as the G sand, predicted compartment
size is much less than calculated drainage area for some wells (Figure 1). For these
compartments, it is inferred that small-displacement faults are ineffective barriers to
cross-
fault
migration of juxtaposed sands over production time scales. This model could be
used to predict drainage areas for oil and gas compartments located by seismic attribute
mapping that were not drilled into previously.
In summary, at a regional scale, evolving migration patterns tracked structural history, and recently active faults acted as the most likely conduit for hydrocarbon flow. Large and small faults formed a network of migration pathways, and vertical and horizontal migration within the field was controlled by effective directional permeability of faults and/or juxtaposition. Applications of this study to risk mitigation include
·prediction of previously untapped compartments,
·prediction of oil/gas type based on existing patterns, and
·prediction of effective compartment
size from analysis of fault
-seal effectiveness.
Figure
1. Schematic map of the G sand, Ship Shoal blocks 274 and 293. Large-displacement faults A
and B and related small-displacement faults are shown in black. Three-dimensional patterns
of oil geochemistry are projected onto the G sand and are shown in shades of gray (as
indicated by the key). Large circles indicate calculated drainage area from G-sand
production data for wells shown by small circles (the small white circle indicates a
gas-producing well and the small black circle indicates an oil-producing well).
Figure 2. Schematic 3-D model of changing patterns of hydrocarbon migration, Ship
Shoal 274 and vicinity. Faults A and B and associated synthetic and antithetic
small-displacement faults are represented by curved surfaces. Above, black arrows indicate
early migration of parent oil up faults of the A family. Below, black arrows indicate late
migration of gas up faults of the B family and the NW-SE trending section of the A
fault
and its associated antithetics.