About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Special Volumes
Abstract
DOI:10.1306/1060767H23170
2005 by The American Association of Petroleum Geologists.
Using Gas Chimneys in Seal Integrity Analysis: A Discussion Based on
Case
Histories
![Previous Hit](/data/images/arrow_left.gif)
![Next Hit](/data/images/arrow_right.gif)
Roar Heggland
Statoil ASA, Stavanger, Norway
ACKNOWLEDGMENTS
Statoil ASA is acknowledged for the use of their data and the permission to publish this chapter.
ABSTRACT
Gas chimneys are visible in seismic data as columnar disturbances, where the continuity of reflectors is missing, and reflection amplitudes are weaker than in the surrounding areas. In this chapter, gas chimneys interpreted from three-dimensional seismic data, some of which have been confirmed by wells, have been sorted into two kinds. Type 1 chimneys are associated with faults. These chimneys commonly have a circular and limited horizontal cross section with a diameter in the order of 100 m (330 ft). The presence of gas chimneys along faults indicates that the faults are open or have been open for a time, in which case
fluids can migrate through the faults. Type 2 chimneys are not associated with faults, and their lateral extent can be in the order of several hundred meters. Because open faults are not capillary barriers for hydrocarbons, as opposed to shales, type 1 chimneys can indicate hydrocarbon-
migration
pathways where relatively high flux rates can occur. Because type 2 chimneys are not associated with faults, capillary resistance in the shales will prevent upward movement of free gas (and oil), and the chimneys are regarded to represent gas having a very slow or no upward movement (low to zero flux rate). However, fractures beyond seismic resolution may exist, which may account for gas
migration
through the shales. Another explanation for the presence of gas type 2 chimneys is that gas-saturated water may release gas during upward movement caused by a drop in the pressure.
Examples from the North Sea, Gulf of Mexico, Nigeria, and the Caspian Sea show a consistency in the appearance and distribution of types 1 and 2 chimneys above hydrocarbon-charged reservoirs, as well as above dry reservoirs. Type 1 chimneys have also been observed below hydrocarbon-charged reservoirs, in which case
, they indicate
migration
pathways into the reservoir.
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
Watermarked PDF Document: $14 | |
Open PDF Document: $24 |