About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Special Volumes
Abstract
Sigal, R. F., C. Rai, C. Sondergeld, B. Spears, W. J. Ebanks Jr., W. D. Zogg, N. Emery, G. McCardle, R. Schweizer, W. G. McLeod, and J. Van Eerde, 
, in
DOI:10.1306/13201130M892598
2009 by The American Association of Petroleum Geologists.
Characterization of a Sediment Core from Potential Gas-hydrate-bearing Reservoirs in the Sagavanirktok, Prince Creek, and Schrader Bluff Formations of Alaska's North Slope: Part 5—Acoustic Velocity Core Studies
R. F. Sigal,1 C. Rai,2 C. Sondergeld,3 B. Spears,4 W. J. Ebanks Jr.,5 W. D. Zogg,6 N. Emery,7 G. McCardle,8 R. Schweizer,9 W. G. McLeod,10 J. Van Eerde11
1Mewbourne School of Petroleum and Geological Engineering, University of Oklahoma, Norman, Oklahoma, U.S.A.
2Mewbourne School of Petroleum and Geological Engineering, University of Oklahoma, Norman, Oklahoma, U.S.A.
3Mewbourne School of Petroleum and Geological Engineering, University of Oklahoma, Norman, Oklahoma, U.S.A.
4Mewbourne School of Petroleum and Geological Engineering, University of Oklahoma, Norman, Oklahoma, U.S.A.
5Consultant, College Station, Texas, U.S.A.
6PTS Labs, Houston, Texas, U.S.A.; Present address: Marathon Oil Corp., Houston, Texas, U.S.A.
7PTS Labs, Houston, Texas, U.S.A.
8PTS Labs, Houston, Texas, U.S.A.
9PTS Labs, Houston, Texas, U.S.A.
10Lone Wolf Oilfield Consulting, Calgary, Alberta, Canada
11Consultant, Calgary, Alberta, CanadaEditor's note: This report is part of a five-report series on the geologic, petrophysical, and geophysical analysis of a sediment core recovered from the Hot Ice 1 gas-hydrate research well drilled in northern Alaska during 2003–2004. Each of these reports (Chapters 25–29 of this volume) deals with specific topical observations and/or core measurements, including (part 1) project summary and geological description of the core; (part 2) porosity, permeability, grain density, and bulk modulus core studies; (part 3) electrical resistivity core studies; (part 4) nuclear magnetic resonance core studies; and (part 5) acoustic velocity core studies.
ABSTRACT
The Anadarko Hot Ice 1 well was cored as part of a project to study the occurrence of gas hydrate on the North Slope of Alaska. The observations and measurements made at the drill site along with the subsequent core analysis are described in five individual reports published in this Memoir. This report deals with the acoustic velocity measurements made on the recovered core.
Velocity measurements were made on the core-sample plugs from the sands recovered during both phase I and phase II coring operations at the Hot Ice 1 well. Polarized shear-wave and compressional-wave ultrasonic velocities at multiple confining stresses were measured on 1-in. (2.54-cm) horizontal plugs. The phase I unconsolidated sandstone-core samples were recovered from the permafrost zone; they were obtained frozen, and the velocities were measured in that recovered state. At 800 psi (5.5 MPa) confining stress, the median compressional velocity is 3810 m/s (12,500 ft/s). Only a very weak dependence on temperature is observed. The median shear velocity is 2170 m/s (7119 ft/s). No significant shear-wave anisotropy was observed. The trend of decreasing velocity with increasing temperature is weak. Based on nuclear magnetic resonance and resistivity measurements, these samples had liquid porosities of a few percent. These velocities are consistent with a model in which ice acts as some combination of cement and a stress-supporting matrix material.
The phase II unconsolidated sand samples were recovered from unfrozen sediment. Polarized shear and compressional velocities were measured on cleaned, dried, and brine-resaturated samples. At 800 psi (5.5 MPa), the median compressional velocity is 2040 m/s (6693 ft/s) and the shear velocity is 1080 m/s (3543 ft/s). No significant shear-wave anisotropy was observed. The sands below 1900 ft (580 m) appear to be more consolidated than the shallower sands. This is reflected in a velocity increase.
Two shale samples, one from 1800 ft (549 m) and one from 2000 ft (610 m), were selected for velocity measurement. Measurements were made on horizontal, vertical, and 45
plugs. At both depths at 800 psi (5.5 MPa), the compressional horizontal velocity was 2100 m/s (6890 ft/s) and the vertical velocity was 1900 m/s (6233 ft/s). Both components of shear-wave velocity at 800 psi (5.5 MPa) were approximately 1000 m/s (3281 ft/s).
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
| Watermarked PDF Document: $14 | |
| Open PDF Document: $24 |