AAPG Studies in Geology No. 50,
(Section Title: General Geology of the Ferron Sandstone) Chapter 9: Petrophysics of the
Cretaceous Ferron Sandstone, Central Utah, by Richard D. Jarrard, Carl H. Sondergeld,
Marjorie A. Chan, and Stephanie N. Erickson, Pages 226 - 250
from:
AAPG Studies in Geology No. 50: Regional
to Wellbore Analog for Fluvial-Deltaic Reservoir Modeling: The Ferron Sandstone of Utah,
Edited by Thomas C. Chidsey, Jr., Roy D. Adams, and Thomas H. Morris
Copyright © 2004 by The American Association of Petroleum Geologists and the
Society of Exploration Geophysicists. All rights reserved.
General Geology of the Ferron
Sandstone
Chapter 9:
Petrophysics of the Cretaceous Ferron Sandstone, Central Utah
Richard D. Jarrard1, Carl H. Sondergeld2,
Marjorie A. Chan1, and Stephanie N. Erickson3
1Department of Geology and Geophysics, University of Utah, Salt Lake
City, Utah
2Mewbourne School of Petroleum and Geological Engineering, University of
Oklahoma, Tulsa, Oklahoma
3ConocoPhillips Alaska, Inc., Anchorage, Alaska
"Wild men armed," Charles
T. Lupton second from the left, circa 1910. Photograph courtesy of the family of C. T.
Lupton.
End_Page 226------------------------
ABSTRACT
The fluvial-deltaic sandstones of the Cretaceous Ferron Sandstone, Utah,
provide an opportunity to document and compare petrophysical properties of outcrop and
subsurface rocks. We find that the processes that generate outcrop exposures -- uplift,
erosion, and exhumation -- can overprint patterns of velocity, porosity, and permeability
developed in the subsurface. Burial to depths of 3000-3400 m (9800-11,100 ft), with
associated compaction and carbonate cementation, was followed by uplift, which exhumed
different portions of the Ferron Sandstone by 0 to >3400 m. Acomplex diagenetic history
culminated with the development of secondary intergranular porosity by carbonate
dissolution during exhumation, because of increasing groundwater flux at depths shallower
than ~2 km (7000 ft) subsurface. Velocity logs show velocity decreases larger than
expected from porosity increase; we attribute the excess to presence of microcracks.
Outcrop plugs exhibit even higher porosity and lower velocity than shallow logs, probably
because of enhanced leaching of carbonate cement. Ferron coreplug and log velocity
responses to this secondary porosity are comparable to that of primary intergranular
porosity, but these samples lack permeability anisotropy and sensitivity of velocity and
permeability to clay content, both of which are typical of primary porosity. Ferron
Sandstone permeability is very closely related to porosity, and therefore exhumation
increases permeability by porosity enhancement. The influence of grain size on porosity
and permeability persists after both initial compaction/cementation, and subsequent
exhumation and secondary porosity development. Consequently, Ferron outcrop stratigraphy
can provide useful clues to fluid-flow patterns in other deltaic formations, despite its
complex diagenetic history.