About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Special Volumes
Abstract
Sandstone
) Chapter 9: Petrophysics of the
Cretaceous Ferron
Sandstone
, Central Utah
from
:
Sandstone
of UtahGeneral Geology of the Ferron
Sandstone
Chapter 9:
Petrophysics of the Cretaceous Ferron
Sandstone
, Central Utah
Richard D. Jarrard1, Carl H. Sondergeld2,
Marjorie A. Chan1, and Stephanie N. Erickson3
1Department of Geology and Geophysics, University of Utah, Salt Lake
City, Utah
2Mewbourne School of Petroleum and Geological Engineering, University of
Oklahoma, Tulsa, Oklahoma
3ConocoPhillips Alaska, Inc., Anchorage, Alaska
"Wild men armed," Charles
T. Lupton second
from
the left, circa 1910. Photograph courtesy of the family of C. T.
Lupton.
End_Page 226------------------------
ABSTRACT
Sandstone
, Utah,
provide an opportunity to document and compare petrophysical properties of outcrop and
subsurface rocks. We find that the processes that generate outcrop exposures -- uplift,
erosion, and exhumation -- can overprint patterns of velocity, porosity, and
permeability
developed in the subsurface. Burial to depths of 3000-3400 m (9800-11,100 ft), with
associated compaction and carbonate cementation, was followed by uplift, which exhumed
different portions of the Ferron
Sandstone
by 0 to >3400 m. Acomplex diagenetic history
culminated with the development of secondary intergranular porosity by carbonate
dissolution during exhumation, because of increasing groundwater flux at depths shallower
than ~2 km (7000 ft) subsurface. Velocity logs show velocity decreases larger than
expected
from
porosity increase; we attribute the excess to presence of microcracks.
Outcrop plugs exhibit even higher porosity and lower velocity than shallow logs, probably
because of enhanced leaching of carbonate cement. Ferron coreplug and log velocity
responses to this secondary porosity are comparable to that of primary intergranular
porosity, but these samples lack
permeability
anisotropy and sensitivity of velocity and
permeability
to clay content, both of which are typical of primary porosity. Ferron
Sandstone
permeability
is very closely related to porosity, and therefore exhumation
increases
permeability
by porosity enhancement. The influence of grain size on porosity
and
permeability
persists after both initial compaction/cementation, and subsequent
exhumation and secondary porosity development. Consequently, Ferron outcrop stratigraphy
can provide useful clues to fluid-flow patterns in other deltaic formations, despite its
complex diagenetic history.
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
| Watermarked PDF Document: $16 | |
| Open PDF Document: $28 |
