About This Item

Share This Item

The AAPG/Datapages Combined Publications Database

AAPG Bulletin

Abstract


Volume: 50 (1966)

Issue: 9. (September)

First Page: 2031

Last Page: 2031

Title: Logging Observation Wells in an In Situ Combustion Test: ABSTRACT

Author(s): H. B. Evans, C. H. Cotterell, H. Surkalo, W. L. Kinney

Article Type: Meeting abstract

Abstract:

The Fry In Situ Combustion Test was conducted in a 3.3-ac. site in the Robinson Sandstone. Six observation wells were cored through the reservoir during various stages of expansion of the combustion front. These cores were sampled for porosity, permeability, grain density, formation factor, saturation exponent, residual fluids, and clay content. These data and core examinations show that the reservoir consists of three sandstone units, each having distinct reservoir properties.

Several combinations of logging devices were run in the observation wells to evaluate their effectiveness in tracking the front laterally and in estimating the degree of combustion vertically.

Gamma-ray-neutron, density, induction, and focused resistivity logs were run open-hole in two wells after combustion. Core, GRAPE,(FOOTNOTE *) and density-log porosity were compared with neutron-derived porosity. Both gas saturation and Previous HitinvadedTop-zone water saturations were calculated. Both methods outline the vertical variations in combustion. In two wells, no logs were run before casing was set. Conventional neutron logs were run through casing but it was necessary to construct departure curves for the conditions encountered. Gas saturations were calculated using the neutron-derived porosity values and core or GRAPE porosity values. This technique yields a qualitative picture of the vertical combustion distribution.

A small-diameter neutron device was run through tubing in one well. In this well, the device was run before the front reached the well and again after combustion occurred. This technique permits evaluation of the vertical extent of combustion using just the ratio of the two response curves.

Of the combinations listed, the neutron-density-focused-contact-resistivity program was most effective in open hole for quantitative determinations of the degree of vertical combustion. In cased holes, the neutron device was satisfactory for identifying the burned zone but the logging program was not designed for quantitative interpretation.

End_of_Article - Last_Page 2031------------

Copyright 1997 American Association of Petroleum Geologists