About This Item
- Full TextFull Text(subscription required)
- Pay-Per-View PurchasePay-Per-View
Purchase Options Explain
Share This Item
The AAPG/Datapages Combined Publications Database
AAPG Bulletin
Abstract
AAPG Bulletin, V.
2003. The American Association of Petroleum Geologists. All rights reserved.
Three-dimensional inverse modeling of the refractive heat-flow anomaly associated with salt diapirism
Seiichi Nagihara1
1Department of Geosciences, Texas Tech University, Lubbock, Texas 79409-1053; email: [email protected]
AUTHORS
Seiichi Nagihara is an assistant professor of geosciences at Texas Tech University. He received his B.S. and M.S. degrees (both in geophysics) from Chiba University, Japan. He received his Ph.D. in geological sciences at the University of Texas at Austin. His research interests are in sedimentary basin modeling, geothermal heat and fluid transport, and geospatial information sciences.
ACKNOWLEDGMENTS
Partial funding for this research was obtained as grants from the Texas Higher Education Coordinating Board and TDI-Brooks International. Comments from John Lorenz, John Doveton, and an anonymous reviewer were helpful in improving the manuscript.
ABSTRACT
This article introduces a technique for three-dimensional inverse modeling of geothermal heat conduction through heterogeneous media. The technique is used to determine the basal geometry of a diapiric salt structure found on the continental slope offshore Texas. Salt is two to four times more thermally conductive than other sedimentary rocks. The geothermal field is perturbed by the presence of salt and results in an anomaly in the heat flow through the seafloor. The spatial variation pattern of the anomalous heat flow reflects the geometry of the salt body. The inverse modeling obtains a model for the thermal-conductivity structure that causes the heat-flow anomaly observed on the seafloor. The inversion algorithm systematically searches for an optimal thermal-conductivity model by iteratively minimizing the misfit between the model-predicted and the observed heat flow. To reduce the problem of nonuniqueness, the inversion incorporates a priori information constrained independently, such as the upper surface geometry of the salt and the lateral extent of the salt body, which can be delineated by a limited coverage of two-dimensional seismic data. In addition, it is assumed that the thermal conductivity of the sedimentary strata surrounding the salt body is well constrained. This inversion method is applied to a heat-flow data set obtained over a salt structure on the Texas continental slope. The salt structure was first surveyed with the single-channel seismic reflection, which yielded the a priori information necessary. The base of the salt was not imaged seismically. Then, three dozen heat-flow measurements were obtained on the seafloor over and off the salt feature. The inverse heat-flow modeling performed here shows that this structure is a salt tongue, which has a diapiric root on one side. According to the most optimal thermal-conductivity model obtained, the root seems to extend to 6 km below the seafloor. Refinement in the model geometry and additional constraints on thermal conductivities of the surrounding strata should yield a model that is more detailed and would allow more thorough geological interpretation of the salt structure.
Pay-Per-View Purchase Options
The article is available through a document delivery service. Explain these Purchase Options.
Watermarked PDF Document: $14 | |
Open PDF Document: $24 |
AAPG Member?
Please login with your Member username and password.
Members of AAPG receive access to the full AAPG Bulletin Archives as part of their membership. For more information, contact the AAPG Membership Department at [email protected].